A petcock is a small shut-off valve used to control the flow of liquid or gas. Historically, petcocks were threaded valves controlled by a butterfly handle; modern petcocks are typically ball valves.

What is the purpose of a motorcycle petcock?

A petcock, or sometimes referred to as a fuel tap or fuel valve, is a 2 or 3 way valve on the bottom of your fuel tank. It works by directing fuel from your tank to the carburetors or fuel injectors. Fuel is pulled by either gravity or vacuum from the fuel system.

What position should my petcock be in?

The valve positions for a manual petcock are “on,” “off” and usually “reserve.” Vacuum petcocks are less important for this discussion since they are usually left in the “run” position and are opened and closed automatically by the engine vacuum of a running (or not running) engine.

Why do you need a petcock?

The petcocks purpose is to prevent fuel flow from the fuel tank to the motorcycles carburetors. They have this in part because motorcycles spend a large chunk of their lives parked on a sidestand. And the petcocks prevent the fuel from overloading the float seals on the “downhill” side of the bike.

Do fuel injected motorcycles have a petcock?

Gasoline essential to the proper operation of your motorcycle is controlled by a “Fuel Control Valve” otherwise known as a “Petcock”. … Fuel-Injected motorcycles rarely have a petcock. Your carbureted bike will have one of the following: Manual Operation.

How does reserve work on a petcock?

On the Ninja 250, when the long side of the petcock handle is pointed straight down, it’s in the On position. The Reserve setting is just like finding a longer straw. It allows you to get that last 20% of the fuel in the tank. It’s not a separate tank, just a separate straw.

What happens if you leave the gas on on your motorcycle?

The primary reason for shutting off the fuel is safety. On a motorcycle the fuel tank is directly above the engine. If fuel were to leak it would drip directly on the hot engine. This along with the fact that most motorcycles use a rubber supply hose that is exposed to the engine heat and the resulting decomposition.

Why is it called petcock?

petcock (n.) also pet-cock, “a small plug-cock, made to be fastened to a pipe and used for draining water and condensation from steam cylinders, etc.,” 1864, from cock (n. 2); the signification of the first element is uncertain.

What is a petcock urinal?

Urinal Cistern Plastic Side Filling Petcock. A plastic filling pet cock for urinal cisterns, this petcock slowly fills up the cistern after the auto flush has emptied. Has a standard 1/2 inch thread and can be adjusted by removing the end cap and twisting the valve inside to control fill rate.

When should I put my bike on reserve?

ON -At “ON” position fuel will flow from fuel tank to the carburetor. RES -At “RES” position fuel will flow from the reserve fuel supply to the carburetor. Use the reserve fuel only when the main supply is exhausted.

Article first time published on

Should Turn Petcock off?

No, there is no legal requirement that you should turn the petcock to “OFF” when you shut your bike down at the end of your ride. However, it is a good practice, especially if you own an older motorcycle (1990s vintage or earlier), before gravity-fed carburetors were largely replaced with fuel injection systems.

What is a Petcock on a scooter?

Most scooters use a vacuum actuated petcock. That means fuel flows from the fuel tank to the carburetor only when the engine is cranking or running. To test the petcock, disconnect the fuel line from the carburetor. … If fuel comes out when you put some vacuum on the petcock, the petcock is working properly.

What does Prime mean on a motorcycle?

So as I understand, the “Prime” position defeats the vacuum of the fuel tank that normally exists when switched to “on.” This allows fuel to go into the engine while parked, and I’ve been told it’s good to do this if it’s cold out or the bike’s been sitting dormant for awhile.

Which way is the fuel on on a motorcycle?

All you need to do is turn the fuel petcock valve located on the left side of your motorcycle near the carburetor, from ON position to RES position. Currently, the fuel valve will be at ‘ON’ position when you run out of gasoline in the main tank.

Do you need fuel Petcock?

Gasoline essential to the proper operation of motorcycle is controlled by a “Fuel Control Valve” otherwise known as a “Petcock”. This valve is characteristically located at the bottom of the fuel tank and can have a number of different configurations.

Why do motorcycles have fuel pumps?

A fuel pump is used to transfer fuel from the tank to the carburetor or fuel injector. A pump is required when the fuel tank is below the fuel system and the force of gravity is insufficient to get fuel to the carburetor.

Is it bad to run motorcycle to empty?

Occasionally running out of gas while riding shouldn’t do much harm to your motorcycle. … You’ll just have to have patience trying to start it back up when you get some gas in the tank because it takes time for the new fuel to enter the fuel system.

Why is my motorcycle backfiring when I accelerate?

Low-Fuel Grade Poor quality of fuel is the main reason why fuel tanks in vehicles end up with dirty gas. … The dirty gas impacts your fuel injection negatively. In the process, your motorbike starts experiencing backfires every time you try to accelerate.

How do you know when a motorcycle needs gas?

Watch the odometer. Figure out how many miles per tank, or per gallon if you only put in a gallon at a time. based on Mileage. If you know you get about say 300km on a tank and you’ve done 250km, you would check to see what the fuel level is like by just opening the tank lid.

Why does my bike run better on reserve?

Why is my motorcycle only running while on reserve? A motorcycle may only run while on reserve because of a clogged petcock screen inside the fuel tank or the three-way valve on the petcock itself is clogged. Another less likely scenario is a failed vacuum line from the carburetor to the petcock.

What will happen if we run the bike in reserve mode when the tank is full?

Running on the reserve tank will give you the miles offered by that tank until you run out of gas. If you run the reserve tank out, the bike will stop.

What is reserve and Main in bike?

MAIN – This is the normal setting when the engine is running. Sometimes this position is labeled “ON” or “RUN”. RESERVE – In this position, a known but small volume of fuel is available to allow the rider to be able to reach a petrol station. The reserve is always a small quantity of the total supply.

How does an automatic toilet flush work?

Automatic toilet flusher uses active infrared sensor technology which uses the emission and reception of infrared beams to detect the presence and movement of objects or people in their field of detection. When the sensor detected the body, it is ready to work. When people leave, it flushes water automatically.

What is a petcock in plumbing?

A petcock is a small shut-off valve used to control the flow of liquid or gas. Historically, petcocks were threaded valves controlled by a butterfly handle; modern petcocks are typically ball valves.

What is the point of a urinal cake?

They’re called “urinal cakes” and are commonly seen at the bottom of urinals. Their purpose? Control bacteria and reduce smell. They’re made of para-dichlorobenzene, a chemical that does deodorize but comes with baggage.

What does a fuel shut off valve do?

Not only does shutting off the fuel valve prevent the engine from flooding while being transported, it prevents flooding because of contamination in the float valve, and extends the life of the float valve by decreasing pressure on it.

What happens if you ride bike with choke on?

By pulling the choke you increase the amount of fuel to the engine.. So.. while starting the vehicle on a cold day, the engine needs more amount of fuel to heat up the engine for normal performance of the vehicle… It is not recommended to put the choke on and drive the bike..

Is it OK to drive bike in reserve?

Yes,we can ride but Everytime if you ride in reserve mode it will effect upon carburetor, engine,and piston because of not enough fuel . and also reserve capacity will be different for every bikes .

What does res mean on fuel switch?

RES is reserve for when you are about to run out of gas you can switch to reserve and get a few more miles out of it. On only lets the fuel flow when the engine is running.

What happens if you leave gas on on dirt bike?

If you let your bike sit for a long time then the fuel in the carb evaporates and can coat/clog the jets.

How long does it take for gas to go bad in a motorcycle?

Unstabilized gas in a motorcycle can start going bad in about 30 days, especially when it is not being used. The exposure to oxygen eventually changes the chemistry of gas which can lead to gum and varnish deposits. Gas should not be used if it has been sitting for longer than 6 months.